Lenovo Thinkpad X1 Carbon 5Th Gen Speakers Replacement Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          30 - 50 minutes            

Sections

3

• Back Cover
• 3 steps
• Battery
• 2 steps
• Speakers
• 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

• BackLenovo ThinkPad X1 Carbon 5th Gen

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The device should be powered off and disconnected from the charger when working on the device.

What you need

Step 1

              Back Cover               

• Turn the laptop on to its back.

Turn the laptop on to its back.

1024

Step 2

• Use the Phillips #1 screwdriver to remove five 1.2 mm screws from the back cover of the laptop.

Use the Phillips #1 screwdriver to remove five 1.2 mm screws from the back cover of the laptop.

Step 3

• Remove the back cover using the opening tool, leaving the laptop back exposed.
• Use the opening tool to pry the edge and work your way around the perimeter.
• Careful to undo the clips before removing the back cover.

Remove the back cover using the opening tool, leaving the laptop back exposed.

Use the opening tool to pry the edge and work your way around the perimeter.

Careful to undo the clips before removing the back cover.

Step 4

              Battery               

• Use the Phillips #1 screwdriver to remove the four 1.2 mm screws that secure the battery.

Use the Phillips #1 screwdriver to remove the four 1.2 mm screws that secure the battery.

Step 5

• Remove the battery using your hand or a prying tool.

Remove the battery using your hand or a prying tool.

Step 6

              Speakers               

• Use the Phillips #1 screwdriver to remove the two 1.2 mm screws.

Use the Phillips #1 screwdriver to remove the two 1.2 mm screws.

Step 7

• Unplug the speaker cable from the board.

Unplug the speaker cable from the board.

Step 8

• Lift up the marked latch and remove the cable.
• Remove the speaker.

Lift up the marked latch and remove the cable.

Remove the speaker.

You will have the speaker replaced and fully working. To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Diego Garcia reyes                     

Member since: 09/01/2021

472 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Gateway, Team 1-3, Saknee Fall 2021                        

                                                  Member of Gateway, Team 1-3, Saknee Fall 2021 



                    GCC-SAKNEE-F21S1G3                     


                                            4 Members                     


                                            6 Guides authored