Lenovo Thinkpad S431 Hdmi Usb Jack Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          15 - 25 minutes            

Sections

2

• Hard Disk Drive
• 5 steps
• HDMI-USB Jack assembly
• 4 steps

Flags

0

• BackLenovo ThinkPad S431

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Hard Disk Drive               

• Remove the 8 screws that hold down the back panel using the Phillips #000 screwdriver.

Remove the 8 screws that hold down the back panel using the Phillips #000 screwdriver.

1024

Step 2

• Remove the two M2 x 3 mm, wafer-head, nylon-coated screws that hold down the hard drive assembly using the Phillips #0 screwdriver.

Remove the two M2 x 3 mm, wafer-head, nylon-coated screws that hold down the hard drive assembly using the Phillips #0 screwdriver.

Step 3

• Pull the hard drive assembly out with backside up.

Pull the hard drive assembly out with backside up.

Step 4

• Remove the four M3 x 3 mm, flat-head, nylon-coated screws on the side of the hard drive assembly using the Phillips #0 screwdriver.

Remove the four M3 x 3 mm, flat-head, nylon-coated screws on the side of the hard drive assembly using the Phillips #0 screwdriver.

Step 5

• Gently, remove the plastic cover with the blue strips.

Gently, remove the plastic cover with the blue strips.

Step 6

              HDMI-USB Jack assembly               

• Remove the 3 screws holding down the T shaped cover using the Phillips head #1. Two of the screws are M2.5x 4 wafer head. The other is a M2x4MM.
• The two similar screws have blue threading around them.

Remove the 3 screws holding down the T shaped cover using the Phillips head #1. Two of the screws are M2.5x 4 wafer head. The other is a M2x4MM.

The two similar screws have blue threading around them.

Step 7

• Use the opening tool to lift up the T shaped cover.
• Remove the M2x3MM wafer head screw.

Use the opening tool to lift up the T shaped cover.

Remove the M2x3MM wafer head screw.

Step 8

• Take off the 2 M2x3MM wafered screws holding down the chip top of assembly.
• Lift the chip to release the HDMI-USB jack assembly

Take off the 2 M2x3MM wafered screws holding down the chip top of assembly.

Lift the chip to release the HDMI-USB jack assembly

Step 9

• Detach the connector.

Detach the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Mohammed AlManai                     

Member since: 04/05/2018

636 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       Linn Benton Community College, Team S2-G2, Johnson Spring 2018                        

                                                  Member of Linn Benton Community College, Team S2-G2, Johnson Spring 2018 



                    LBCC-JOHNSON-S18S2G2                     


                                            4 Members                     


                                            7 Guides authored