Difficulty

Moderate

Steps

5

Time Required

                          20 minutes

Sections

2

  • Battery
  • 4 steps
  • Vibrating Cable
  • 1 step

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackLenovo Miix 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the back cover of the tablet by inserting a nylon or metal spudger in the small hole between the screen and rear cover near the volume button. Slide the tool along the edge of the tablet to release the internal clasps.
  • You should have to apply a good amount of force, but pry carefully in order to avoid damaging the clasps or the internals.

Remove the back cover of the tablet by inserting a nylon or metal spudger in the small hole between the screen and rear cover near the volume button. Slide the tool along the edge of the tablet to release the internal clasps.

You should have to apply a good amount of force, but pry carefully in order to avoid damaging the clasps or the internals.

1024

Step 2

  • Unscrew the six 3mm screws surrounding the battery dock using a Phillips #0 screwdriver.

Unscrew the six 3mm screws surrounding the battery dock using a Phillips #0 screwdriver.

Step 3

  • Using a plastic spudger, slowly push each side of the battery connector (back and forward a couple of times) out of its socket on the motherboard.

Using a plastic spudger, slowly push each side of the battery connector (back and forward a couple of times) out of its socket on the motherboard.

Step 4

  • Remove the battery by prying up with your fingers or a plastic opening tool.

Remove the battery by prying up with your fingers or a plastic opening tool.

Step 5

              Vibrating Cable
  • Remove the vibrator cable which is connected with a white connector head to the motherboard, by gently lifting on the connector head with tweezers.
  • Remove the vibrator head by following the black and wire cable from the motherboard to where the head is located.

Remove the vibrator cable which is connected with a white connector head to the motherboard, by gently lifting on the connector head with tweezers.

Remove the vibrator head by following the black and wire cable from the motherboard to where the head is located.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Max Rozema

Member since: 04/02/2019

157 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       IUPUI, Team S3-G1, Harley Spring 2019                        

                                                  Member of IUPUI, Team S3-G1, Harley Spring 2019 



                    IUPUI-HARLEY-S19S3G1                     


                                            3 Members                     


                                            2 Guides authored