Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

2

  • Battery
  • 6 steps
  • Vibration Motor
  • 1 step

Flags

0

  • BackLenovo IdeaTab S6000

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the speaker screens by working them loose with a plastic opening tool. You may need to first loosen them with tweezers or a craft knife.
  • These screens are held in place by glue that is hard to remove. Please take your time to ensure that that this step is done correctly.

Remove the speaker screens by working them loose with a plastic opening tool. You may need to first loosen them with tweezers or a craft knife.

These screens are held in place by glue that is hard to remove. Please take your time to ensure that that this step is done correctly.

1024

Step 2

  • Remove the screws from both of the spots that were covered.

Remove the screws from both of the spots that were covered.

Step 3

  • DO NOT USE A METAL TOOL FOR THIS.
  • Go all around the casing, prying the screen away from the backing with the spudger.
  • It will make a popping sound each time one of the lock tabs is disconnected.
  • Take your time as you move all around the device when prying the backing off.

DO NOT USE A METAL TOOL FOR THIS.

Go all around the casing, prying the screen away from the backing with the spudger.

It will make a popping sound each time one of the lock tabs is disconnected.

Take your time as you move all around the device when prying the backing off.

Step 4

  • Pull off the plastic that is covering the battery cable.

Pull off the plastic that is covering the battery cable.

Step 5

  • Using either the plastic opening tool or your fingers, gently pull on both sides of the plug to release it.

Using either the plastic opening tool or your fingers, gently pull on both sides of the plug to release it.

Step 6

  • Remove the battery by grabbing the tab shown and pulling up.
  • The battery is held to the device by adhesive. Pull the battery up from the tab and it will lift out with a bit of effort.

Remove the battery by grabbing the tab shown and pulling up.

The battery is held to the device by adhesive. Pull the battery up from the tab and it will lift out with a bit of effort.

Step 7

              Vibration Motor
  • Use the spudger to pry up the vibration motor.

Use the spudger to pry up the vibration motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Gabriel Delgado

Member since: 09/22/2014

244 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 10-4, Brown Fall 2014                        

                                                  Member of USF Tampa, Team 10-4, Brown Fall 2014 



                    USFT-BROWN-F14S10G4                     


                                            4 Members                     


                                            10 Guides authored