Difficulty
Easy
Steps
9
Time Required
10 - 15 minutes
Sections
2
- Battery
- 3 steps
- Speaker
- 6 steps
Flags
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
Better Introduction
Improve this guide by completing or revising its introduction.
BackLenovo IdeaTab S2109A-F
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn the tablet off before beginning this guide. It is dangerous to touch internal components while the tablet is on.
- Place the tablet on its screen and use the opening tool to remove the back cover.
- With the tool, place slight pressure on the tablet to pry the back panel off.
Turn the tablet off before beginning this guide. It is dangerous to touch internal components while the tablet is on.
Place the tablet on its screen and use the opening tool to remove the back cover.
With the tool, place slight pressure on the tablet to pry the back panel off.
1024
Step 2
- Grab the battery and gently lift upwards. This will show a red and black coiled wire.
- Pull the battery gently until the cord has no slack.
Grab the battery and gently lift upwards. This will show a red and black coiled wire.
Pull the battery gently until the cord has no slack.
Step 3
- Carefully hold the battery in one hand while your other hand’s index finger and thumb grab the two wires nearest to their connection point.
- Use your fingers to give a firm tug to the black and red wires, but do not yank them hard enough to damage the tablet.
- Remove the battery from the device.
Carefully hold the battery in one hand while your other hand’s index finger and thumb grab the two wires nearest to their connection point.
Use your fingers to give a firm tug to the black and red wires, but do not yank them hard enough to damage the tablet.
Remove the battery from the device.
Step 4
Speaker
- Remove the ten 2 mm black screws from the edges of the system board with a Phillips #00 screwdriver.
Remove the ten 2 mm black screws from the edges of the system board with a Phillips #00 screwdriver.
Step 5
- Disconnect the gold connector by lifting the latch with the plastic opening tool.
Disconnect the gold connector by lifting the latch with the plastic opening tool.
Step 6
- Pull up on the L-shaped board.
- The bottom and top connection points should disconnect.
Pull up on the L-shaped board.
The bottom and top connection points should disconnect.
Step 7
- Remove the seven 2 mm black screws connecting the speakers using the Phillips #00 screwdriver.
Remove the seven 2 mm black screws connecting the speakers using the Phillips #00 screwdriver.
Step 8
- Lift the disconnected speakers from their resting position.
- Grab the red and black cable with your index finger and thumb.
Lift the disconnected speakers from their resting position.
Grab the red and black cable with your index finger and thumb.
Step 9
- Pull up on the connection to disconnect the speakers.
Pull up on the connection to disconnect the speakers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Caelen
Member since: 01/16/2015
228 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team 17-3, Watkins Winter 2015
Member of USF Tampa, Team 17-3, Watkins Winter 2015
USFT-WATKINS-W15S17G3
4 Members
10 Guides authored