Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
1
- Digital Board
- 6 steps
Flags
0
BackLenovo IdeaTab A2109
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Digital Board
- Look at the back of the tablet and locate the speakers on top of the rear cover.
- There is a smaller plastic cover that runs across the top of the device.
- Wedge the blue opening tool, under the middle of the cover as shown, then push up and the cover will pop off.
Look at the back of the tablet and locate the speakers on top of the rear cover.
There is a smaller plastic cover that runs across the top of the device.
Wedge the blue opening tool, under the middle of the cover as shown, then push up and the cover will pop off.
1024
Step 2
- Remove the following two screws:
- M3.0 x 3.0 mm #00 phillips screws (black)
Remove the following two screws:
M3.0 x 3.0 mm #00 phillips screws (black)
Step 3
- Once it is unscrewed, remove the rear cover
- This may take a little force to get off but with enough force it should pop right off
- Use a blue opening tool to pry it open
- Slide the tool to one corner then grab another tool and slide it to the opposite corner
- Pull the cover up and it will come off
Once it is unscrewed, remove the rear cover
This may take a little force to get off but with enough force it should pop right off
Use a blue opening tool to pry it open
Slide the tool to one corner then grab another tool and slide it to the opposite corner
Pull the cover up and it will come off
Step 4
- Use the tweezer tool to flip up the three small plastic locks attached to the digital board.
- Then, slide newly exposed ribbons out.
Use the tweezer tool to flip up the three small plastic locks attached to the digital board.
Then, slide newly exposed ribbons out.
Step 5
- Remove the following two screws:
- M5.3 x 1.75 mm #00 phillips screws (silver)
M5.3 x 1.75 mm #00 phillips screws (silver)
Step 6
- Once it is unscrewed, use the tweezer tool to pull the digital board straight out.
Once it is unscrewed, use the tweezer tool to pull the digital board straight out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Brian
Member since: 04/22/2014
565 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 7-19, Regan Spring 2014
Member of Cal Poly, Team 7-19, Regan Spring 2014
CPSU-REGAN-S14S7G19
4 Members
14 Guides authored
