Difficulty

Moderate

Steps

4

Time Required

                          15 minutes

Sections

1

  • Camera Assembly
  • 4 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackLenovo IdeaTab A2109

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera Assembly
  • Look at the back of the tablet and locate the speakers on top of the rear cover.
  • Locate the small indentation in the plastic cover that runs across the top of the device.
  • Wedge the plastic opening tool in this indentation, under the middle of the cover as shown.
  • Pry up and push to remove the cover.

Look at the back of the tablet and locate the speakers on top of the rear cover.

Locate the small indentation in the plastic cover that runs across the top of the device.

Wedge the plastic opening tool in this indentation, under the middle of the cover as shown.

Pry up and push to remove the cover.

1024

Step 2

  • Remove the following two screws:
  • M3.0 x 3.0 mm #00 phillips screws (black)

Remove the following two screws:

M3.0 x 3.0 mm #00 phillips screws (black)

Step 3

  • Pry open the front and rear faces using a plastic opening tool.
  • It may take a little force to separate the front and rear faces of the device.
  • Slide the plastic opening tool to one corner.
  • Place another plastic opening tool into the gap and slide it to the opposite corner as shown.
  • Pull the rear cover up and back to separate it from front face of the device.

Pry open the front and rear faces using a plastic opening tool.

It may take a little force to separate the front and rear faces of the device.

Slide the plastic opening tool to one corner.

Place another plastic opening tool into the gap and slide it to the opposite corner as shown.

Pull the rear cover up and back to separate it from front face of the device.

Step 4

  • Slide the rear camera ribbon from the system board.
  • Pull up on the black plastic lock on the system board for the front camera and slide the ribbon out.
  • Now, you are ready to remove the front and rear facing cameras.

Slide the rear camera ribbon from the system board.

Pull up on the black plastic lock on the system board for the front camera and slide the ribbon out.

Now, you are ready to remove the front and rear facing cameras.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 6 other contributors 


                    Abigail Bertholf

Member since: 04/14/2014

521 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 7-19, Regan Spring 2014                        

                                                  Member of Cal Poly, Team 7-19, Regan Spring 2014 



                    CPSU-REGAN-S14S7G19                     


                                            4 Members                     


                                            14 Guides authored