Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
2
- Bottom Cover
- 2 steps
- Solid State Drive
- 2 steps
Flags
0
BackLenovo IdeaPad U410
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bottom Cover
- Using the metal spudger, remove all the rubber squares on the bottom of the laptop.
Using the metal spudger, remove all the rubber squares on the bottom of the laptop.
1024
Step 2
- Remove the three 6 mm Phillips #1 screws holding the panel on the laptop.
- Pry the panel from the laptop using your hands or the metal spudger if necessary.
Remove the three 6 mm Phillips #1 screws holding the panel on the laptop.
Pry the panel from the laptop using your hands or the metal spudger if necessary.
Step 3
Solid State Drive
- Make sure your laptop is powered off.
- Use a Phillips #1 screwdriver to remove the 3 mm screw holding the SSD in place.
Make sure your laptop is powered off.
Use a Phillips #1 screwdriver to remove the 3 mm screw holding the SSD in place.
Step 4
- Grab the SSD and pull it out from the mSATA slot.
Grab the SSD and pull it out from the mSATA slot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Edric An
Member since: 09/18/2018
433 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
University of North Texas, Team S3-G5, Raign Fall 2018
Member of University of North Texas, Team S3-G5, Raign Fall 2018
UNT-RAIGN-F18S3G5
4 Members
6 Guides authored