Difficulty
Moderate
Steps
11
Time Required
10 - 20 minutes
Sections
2
- Battery
- 5 steps
- RAM
- 6 steps
Flags
0
BackLenovo Ideapad S415 Touch
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
In order to replace the RAM you will first need to remove the battery. Make sure you have a Phillips #0 screw bit or screwdriver on hand. Be careful when dealing with the RAM. When removing it, take extra care not to touch the yellow strip on top of the RAM because the oil from fingers can damage the piece.
What you need
Step 1
Battery
- Flip laptop over bottom side up.
- Locate the two battery release switches.
Flip laptop over bottom side up.
Locate the two battery release switches.
1024
Step 2
- Use your finger to push the battery release switch labeled “1.” The red indicates that the switch is unlocked.
Use your finger to push the battery release switch labeled “1.” The red indicates that the switch is unlocked.
Step 3
- Use your finger to push the battery switch labeled “2.”
Use your finger to push the battery switch labeled “2.”
Step 4
- Once both switches are unlocked, the battery will release.
Once both switches are unlocked, the battery will release.
Step 5
- When replacing the battery make sure the two protruding holes line up with the slot.
- Carefully remove the battery.
When replacing the battery make sure the two protruding holes line up with the slot.
Carefully remove the battery.
Step 6
RAM
- Locate the five 6mm black screws on the bottom.
- Using a Phillips #0 screwdriver, remove all five screws.
Locate the five 6mm black screws on the bottom.
Using a Phillips #0 screwdriver, remove all five screws.
Step 7
- Locate the three 4mm silver screws on the bottom area where the battery was removed.
- Use the Phillips #0 screwdriver to remove all three screws.
Locate the three 4mm silver screws on the bottom area where the battery was removed.
Use the Phillips #0 screwdriver to remove all three screws.
Step 8
- Locate the four rubber stoppers near each corner of the laptop.
- Open up the stoppers by lifting each with your hands.
Locate the four rubber stoppers near each corner of the laptop.
Open up the stoppers by lifting each with your hands.
Step 9
- Under each of the four stoppers, there will be a 6mm screw.
- Use the Phillips #0 screwdriver to remove all four screws.
Under each of the four stoppers, there will be a 6mm screw.
Use the Phillips #0 screwdriver to remove all four screws.
Step 10
- Carefully open up the laptop to reveal the internal components.
Carefully open up the laptop to reveal the internal components.
Step 11
- Locate the RAM.
- Using your hands gently push up on the two silver clips located on both ends of the RAM.
- The RAM will spring out. Gently pull it out of the slot.
- Do not touch the top yellow part of the RAM as this will cause damage.
Locate the RAM.
Using your hands gently push up on the two silver clips located on both ends of the RAM.
The RAM will spring out. Gently pull it out of the slot.
Do not touch the top yellow part of the RAM as this will cause damage.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Alexandria
Member since: 02/05/2019
363 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
UC Davis, Team S20-G5, Lore Winter 2019
Member of UC Davis, Team S20-G5, Lore Winter 2019
UCD-LORE-W19S20G5
3 Members
4 Guides authored