Lenovo Ideapad S400 Touch Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          25 minutes            

Sections

2

• Battery
• 1 step
• Speakers
• 3 steps

Flags

0

• BackLenovo IdeaPad S400 Touch

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Turn your computer over so the back is face up.
• Use your forefinger to unlock the two tabs located on the back. Slide the tabs until you see the red showing.
• The battery cover will then pop up allowing you access to the battery.

Turn your computer over so the back is face up.

Use your forefinger to unlock the two tabs located on the back. Slide the tabs until you see the red showing.

The battery cover will then pop up allowing you access to the battery.

1024

Step 2

              Speakers               

• Remove the five 6mm Phillips #0 screws from the back panel.
• Pull back the rubber tabs from the corners of the laptop backing to expose the screws.
• The two tabs next to battery flip toward the battery. The two remaining tabs flip down, away from the battery.
• Remove the four 4mm Phillips #0 screws that are underneath the rubber tabs.
• Remove the three 6mm Phillips #0 screws from under the battery.

Remove the five 6mm Phillips #0 screws from the back panel.

Pull back the rubber tabs from the corners of the laptop backing to expose the screws.

The two tabs next to battery flip toward the battery. The two remaining tabs flip down, away from the battery.

Remove the four 4mm Phillips #0 screws that are underneath the rubber tabs.

Remove the three 6mm Phillips #0 screws from under the battery.

Step 3

• Slide the back panel away to remove it.
• Don’t be afraid to apply force when removing the back panel.

Slide the back panel away to remove it.

Don’t be afraid to apply force when removing the back panel.

Step 4

• Remove the two 2mm Phillips #0 screws from each speaker.
• Take the speakers off the base.
• Pull the connecting cable from the motherboard, which will release the speakers.
• To install the replacement speakers, follow these steps in reverse order.

Remove the two 2mm Phillips #0 screws from each speaker.

Take the speakers off the base.

Pull the connecting cable from the motherboard, which will release the speakers.

To install the replacement speakers, follow these steps in reverse order.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Max Hoyle                     

Member since: 02/12/2019

529 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Western Carolina University, Team S1-G6, Virtue Spring 2019                        

                                                  Member of Western Carolina University, Team S1-G6, Virtue Spring 2019 



                    WCU-VIRTUE-S19S1G6                     


                                            5 Members                     


                                            5 Guides authored