Lenovo Ideapad S400 Touch Hard Drive Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Battery
1 step
Hard Drive
3 steps

Flags

BackLenovo IdeaPad S400 Touch
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Turn your computer over so the back is face up.
Use your forefinger to unlock the two tabs located on the back. Slide the tabs until you see the red showing.
The battery cover will then pop up allowing you access to the battery.

Turn your computer over so the back is face up.

Use your forefinger to unlock the two tabs located on the back. Slide the tabs until you see the red showing.

The battery cover will then pop up allowing you access to the battery.

1024

Step 2

              Hard Drive

Remove the five 6mm Phillips #0 screws from the back panel.
Pull back the rubber tabs from the corners of the laptop backing to expose the screws.
The two tabs next to the battery flip toward the battery. The two remaining tabs flip down, away from the battery.
Remove the four 4mm Phillips #0 screws that are underneath the rubber tabs.
Remove the three 6mm Phillips #0 screws from under the battery.

Remove the five 6mm Phillips #0 screws from the back panel.

Pull back the rubber tabs from the corners of the laptop backing to expose the screws.

The two tabs next to the battery flip toward the battery. The two remaining tabs flip down, away from the battery.

Remove the four 4mm Phillips #0 screws that are underneath the rubber tabs.

Remove the three 6mm Phillips #0 screws from under the battery.

Step 3

Slide the back panel away to remove it.
Don’t be afraid to apply force when removing the back panel.

Slide the back panel away to remove it.

Don’t be afraid to apply force when removing the back panel.

Step 4

Remove the two 3mm Phillips #0 screws that hold the hard drive to the case.
Take out the hard drive by lifting and sliding it at the same time.

Remove the two 3mm Phillips #0 screws that hold the hard drive to the case.

Take out the hard drive by lifting and sliding it at the same time.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors

                    Max Hoyle

Member since: 02/12/2019

529 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Western Carolina University, Team S1-G6, Virtue Spring 2019                        

                                                  Member of Western Carolina University, Team S1-G6, Virtue Spring 2019 



                    WCU-VIRTUE-S19S1G6                     


                                            5 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team