Difficulty
Moderate
Steps
7
Time Required
10 - 30 minutes
Sections
3
- Lower Case
- 4 steps
- Battery Disconnect
- 1 step
- Left SSD
- 2 steps
Flags
1
Provided Hardware
A manufacturer provided iFixit with this device or component.
BackLenovo IdeaPad Gaming 3 15ACH6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Your laptop might not come with a standoff screw to install an additional SSD. In this case, you’ll need to purchase one.
Before you perform this repair, if at all possible, back up your existing SSD. If you are replacing the SSD where your operating system is installed, familiarize yourself with a disk cloning utility so you’ll be ready to migrate your data to the new SSD.
Be sure to completely power off and unplug your laptop. Make sure the laptop is not in standby, sleep, or hibernation mode.
What you need
Step 1
Unfasten the lower case
- Use a Phillips screwdriver to remove the 10 screws securing the lower case:
- Six 12 mm screws
- Four 4.5 mm screws
Use a Phillips screwdriver to remove the 10 screws securing the lower case:
Six 12 mm screws
Four 4.5 mm screws
1024
Step 2
Insert an opening pick
- Insert an opening pick between the lower case and the chassis on the front right edge.
Insert an opening pick between the lower case and the chassis on the front right edge.
Step 3
Release the clips
- Slide the pick along the front edge to release the clips securing the lower case.
- Continue sliding the opening pick along the left and right edges to release the remaining clips.
Slide the pick along the front edge to release the clips securing the lower case.
Continue sliding the opening pick along the left and right edges to release the remaining clips.
Step 4
Remove the lower case
- Lift the lower case from the chassis and remove it.
- During reassembly, this is a good point to power on your laptop and test all functions before sealing it up. Be sure to power your laptop back down before you continue working.
Lift the lower case from the chassis and remove it.
During reassembly, this is a good point to power on your laptop and test all functions before sealing it up. Be sure to power your laptop back down before you continue working.
Step 5
Disconnect the battery
- Use the pointed end of a spudger to push each side of the battery connector until it comes out of the socket.
Use the pointed end of a spudger to push each side of the battery connector until it comes out of the socket.
Step 6
Unfasten the left SSD
- Use a Phillips screwdriver to remove the 2.4 mm screw securing the left SSD.
Use a Phillips screwdriver to remove the 2.4 mm screw securing the left SSD.
Step 7
Remove the SSD
- Pull the SSD out of its socket and remove it. Keep the SSD as parallel to the motherboard as possible when pulling on it.
- Do not pull up at a sharp angle, as this could damage the SSD and the socket.
Pull the SSD out of its socket and remove it. Keep the SSD as parallel to the motherboard as possible when pulling on it.
Do not pull up at a sharp angle, as this could damage the SSD and the socket.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Lenovo IdeaPad answers community for help.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Spencer Day
Member since: 09/14/2022
11,019 Reputation
84 Guides authored
Badges:
21
+18 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored