Difficulty
Moderate
Steps
10
Time Required
40 - 45 minutes
Sections
3
- Back Panel
- 3 steps
- Battery
- 2 steps
- Daughterboard
- 5 steps
Flags
0
BackLenovo IdeaPad Flex 5-1570
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Particularly for this device, the daughterboard houses the USB port. If you find that your USB devices are not being recognized by the laptop, it may be time to replace the daughterboard of the device. Follow these instructions to remove and replace the daughterboard of your Lenovo IdeaPad Flex 5-1570 laptop.
What you need
Step 1
Back Panel
- Remove the ten 5 mm Phillips #00 screws that are holding the back panel on.
Remove the ten 5 mm Phillips #00 screws that are holding the back panel on.
1024
Step 2
- Use a spudger to pry open the back case at the two hinge cutouts.
- Gently use the plastic opening tool around the edges of the laptop to pry up the clips holding the rest of the back panel.
Use a spudger to pry open the back case at the two hinge cutouts.
Gently use the plastic opening tool around the edges of the laptop to pry up the clips holding the rest of the back panel.
Step 3
- Once all the clips have been disengaged, lift off the back cover.
Once all the clips have been disengaged, lift off the back cover.
Step 4
Battery
- Remove the two 5 mm Phillips #00 screws that secure the battery in place.
Remove the two 5 mm Phillips #00 screws that secure the battery in place.
Step 5
- Using your fingers, grasp the entire bundle of wires to pull the battery cable from its connector. This will cut off power to the motherboard.
- Be sure to apply even pressure across the wires and connector to not damage the battery cable.
- Remove the battery from the device.
Using your fingers, grasp the entire bundle of wires to pull the battery cable from its connector. This will cut off power to the motherboard.
Be sure to apply even pressure across the wires and connector to not damage the battery cable.
Remove the battery from the device.
Step 6
Daughterboard
- Using the plastic opening tool, unlock the connector for the side ports panel and disconnect the cable from the motherboard.
Using the plastic opening tool, unlock the connector for the side ports panel and disconnect the cable from the motherboard.
Step 7
- Using the plastic opening tool, disconnect the CMOS battery from the daughterboard by pushing it out towards the direction of the CMOS battery.
Using the plastic opening tool, disconnect the CMOS battery from the daughterboard by pushing it out towards the direction of the CMOS battery.
Step 8
- Using the Phillips #00 screwdriver, remove the single 5 mm screw.
Using the Phillips #00 screwdriver, remove the single 5 mm screw.
Step 9
- Using the iFixit Opening tool, remove the silver piece of tape from the device.
Using the iFixit Opening tool, remove the silver piece of tape from the device.
Step 10
- Lift the daughterboard up and out of the device.
Lift the daughterboard up and out of the device.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Cancel: I did not complete this guide.
Author
Justin Ogihara
Member since: 09/18/2017
23,793 Reputation
52 Guides authored
Badges:
38
+35 more badges
Team
EDU Team
Member of EDU Team
Community
7 Members
487 Guides authored