Difficulty

Moderate

Steps

10

Time Required

                          25 minutes

Sections

5

  • Back Panel
  • 4 steps
  • Battery
  • 2 steps
  • Fan
  • 2 steps
  • Heat Sink
  • 1 step
  • Wi-Fi Card
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLenovo IdeaPad 320-17IKB

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Back Panel
  • Turn off and unplug the computer.
  • Flip the laptop over so that the back panel is facing upwards.

Turn off and unplug the computer.

Flip the laptop over so that the back panel is facing upwards.

1024

Step 2

  • Remove fourteen 7mm Phillips #00 screws from the back panel.

Remove fourteen 7mm Phillips #00 screws from the back panel.

Step 3

  • Carefully remove the optical drive by pulling the bezel away from the laptop.

Carefully remove the optical drive by pulling the bezel away from the laptop.

Step 4

  • Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop.
  • Lay both sides of the laptop next to each other.

Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop.

Lay both sides of the laptop next to each other.

Step 5

              Battery
  • Remove five 7mm Phillips #0 screws from the battery holder.

Remove five 7mm Phillips #0 screws from the battery holder.

Step 6

  • Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base.
  • When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.

Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base.

When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.

Step 7

              Fan
  • Remove five 7mm Phillips #00 screws from the cooling fan.

Remove five 7mm Phillips #00 screws from the cooling fan.

Step 8

  • Gently lift the fan assembly out of the laptop.
  • Gently remove the connecting wires from the exterior of the fan by slowly “weaving” the cord between the ridges of the fan.

Gently lift the fan assembly out of the laptop.

Gently remove the connecting wires from the exterior of the fan by slowly “weaving” the cord between the ridges of the fan.

Step 9

              Heat Sink
  • Gently lift and remove the heat sink and set it aside.

Gently lift and remove the heat sink and set it aside.

Step 10

              Wi-Fi Card
  • Remove the single 3mm Phillips #0 screw from the Wi-Fi card.
  • Pull the Wi-Fi card straight out of the laptop.

Remove the single 3mm Phillips #0 screw from the Wi-Fi card.

Pull the Wi-Fi card straight out of the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Kristen Gismondi

Member since: 11/12/2014

69,395 Reputation

                                      176 Guides authored                  



                       Badges:
                       44







                                                        +41 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored