Difficulty

Easy

Steps

6

Time Required

                          3 - 6 minutes

Sections

1

  • LED Screen
  • 6 steps

Flags

0

  • BackLenovo IdeaPad 320-17IKB

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

An LED screen is the flat display panel that portrays the images seen on the laptop. It does this through the use of light emitting pixels. Be careful not to bend or twist the LED screen during removal as it can damage the component.

Before replacing this LED screen, check out the Lenovo IdeaPad 320-17IKB Troubleshooting.

What you need

Step 1

              LED Screen
  • Start from the left side of the bezel (plastic covering) by gently removing inner edge of the plastic. Continue to do the same thing on the right side.

Start from the left side of the bezel (plastic covering) by gently removing inner edge of the plastic. Continue to do the same thing on the right side.

1024

Step 2

  • Turn the laptop sideways and insert the plastic pick between the bezel (plastic covering) and the laptop cover. Use the plastic pick to separate the bezel from the top cover.

Turn the laptop sideways and insert the plastic pick between the bezel (plastic covering) and the laptop cover. Use the plastic pick to separate the bezel from the top cover.

Step 3

  • Remove the bezel (plastic covering) from the laptop completely and set aside.
  • Do not twist or bend the LED screen or the bezel. Doing so could result in permanent damage to the LED screen or injury to yourself.

Remove the bezel (plastic covering) from the laptop completely and set aside.

Do not twist or bend the LED screen or the bezel. Doing so could result in permanent damage to the LED screen or injury to yourself.

Step 4

  • Remove the four 7mm JIS #00 screws from each corner while holding the screen in place.

Remove the four 7mm JIS #00 screws from each corner while holding the screen in place.

Step 5

  • Place the LED screen on the keyboard and use your fingers or the iFixit opening tool to open the bracket securing the video connector. Then, disconnect the video cable.

Place the LED screen on the keyboard and use your fingers or the iFixit opening tool to open the bracket securing the video connector. Then, disconnect the video cable.

Step 6

  • Once all the other steps have been completed you should have a disconnected LED screen, and bezel. The connector tab should remain adhered to the motherboard.

Once all the other steps have been completed you should have a disconnected LED screen, and bezel. The connector tab should remain adhered to the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    a1235

Member since: 09/02/2019

554 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Embry-Riddle Aeronautical University, Team S6-G3, Salas Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G3, Salas Fall 2019 



                    ERAU-SALAS-F19S6G3                     


                                            4 Members                     


                                            5 Guides authored

Jason - Mar 26, 2020

Reply

Is there a direct replacement better quality panel?

P SANDEEP - Mar 7, 2022

Reply

does this laptop have backlights on keyboard ????????