Lenovo Ideapad 310 Touch 15Isk Fan Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 - 15 minutes            

Sections

1

• Fan
• 5 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

• BackLenovo IdeaPad 310 Touch-15ISK

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Fan               

• First, begin by flipping the laptop over, so the bottom is facing up.
• Then, start removing the 13 screws found at the bottom to remove the bottom. Size: Phillips #0
• After removing the bottom, remove the 3 extra screws located in the RAM port. Size: Phillips #0

First, begin by flipping the laptop over, so the bottom is facing up.

Then, start removing the 13 screws found at the bottom to remove the bottom. Size: Phillips #0

After removing the bottom, remove the 3 extra screws located in the RAM port. Size: Phillips #0

1024

Step 2

• Then begin by disconnecting the keyboard and the touchpad.
• Also, remove the CD drive.

Then begin by disconnecting the keyboard and the touchpad.

Also, remove the CD drive.

Step 3

• Proceed to flip the laptop back over so now it is right-side up.
• Using a plastic spudger, pry between the keyboard panel and bottom panel on all 4 sides.

Proceed to flip the laptop back over so now it is right-side up.

Using a plastic spudger, pry between the keyboard panel and bottom panel on all 4 sides.

Step 4

• Begin by removing the 4 screws and also the tabs that are holding down the motherboard.
• Be sure to disconnect the fan tab on the bottom of the motherboard

Begin by removing the 4 screws and also the tabs that are holding down the motherboard.

Be sure to disconnect the fan tab on the bottom of the motherboard

Step 5

• Finally remove the one screw that is holding the fan. Size: Phillips #0

Finally remove the one screw that is holding the fan. Size: Phillips #0

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    msegundo23                     

Member since: 09/21/2017

225 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Washington State, Team S5-G7, Phelps-Hillen Fall 2017                        

                                                  Member of Washington State, Team S5-G7, Phelps-Hillen Fall 2017 



                    WSU-PHELPS-HILLEN-F17S5G7                     


                                            4 Members                     


                                            8 Guides authored