Lenovo Ideapad 100S 14Ibr Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          7 minutes

Sections

Speaker
5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackLenovo IdeaPad 100s-14IBR
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Speaker

Remove the eight 4mm PH00 screws.
Remove the four 2mm PH00 screws.

Remove the eight 4mm PH00 screws.

Remove the four 2mm PH00 screws.

1024

Step 2

Use the nylon spudger to loosen the back cover from the back of the device.
You may hear a bit of a snapping sound, but this is normal.

Use the nylon spudger to loosen the back cover from the back of the device.

You may hear a bit of a snapping sound, but this is normal.

Step 3

For safety reasons, disconnect the wires connecting the battery to the motherboard with the nylon spudger.
Remove the six 4mm Phillips #00 screws.
Remove the battery using the nylon spudger.

For safety reasons, disconnect the wires connecting the battery to the motherboard with the nylon spudger.

Remove the six 4mm Phillips #00 screws.

Remove the battery using the nylon spudger.

Step 4

Remove the four 2mm PH00 screws.
Unplug the speakers from the motherboard.
Remove the two 4mm PH00 screws from the metal shield on the trackpad.
Lift the metal shield up slightly, being very careful not to move the ribbon cables too much. Move the speaker cables out from under the shield.

Unplug the speakers from the motherboard.

Remove the two 4mm PH00 screws from the metal shield on the trackpad.

Lift the metal shield up slightly, being very careful not to move the ribbon cables too much. Move the speaker cables out from under the shield.

Step 5

Lift the speakers from the case being careful of the wires connecting them. Put them to the side.

Lift the speakers from the case being careful of the wires connecting them. Put them to the side.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Bin Feng

Member since: 03/18/2019

256 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of Memphis, Team S1-G3, Kim Spring 2019                        

                                                  Member of University of Memphis, Team S1-G3, Kim Spring 2019 



                    UM-KIM-S19S1G3                     


                                            3 Members                     


                                            9 Guides authored

Better Introduction#

Introduction#

What you need#

Team#

Better Introduction

Introduction

What you need

Team