Difficulty
Moderate
Steps
10
Time Required
10 - 15 minutes
Sections
3
- Battery
- 3 steps
- Back Panel
- 3 steps
- Keyboard
- 4 steps
Flags
0
BackLenovo Essential G560
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off the computer.
- Disconnect the charging cable from the computer.
- Failure to unplug the cable could result in electric shock.
- Flip the computer upside down.
Turn off the computer.
Disconnect the charging cable from the computer.
Failure to unplug the cable could result in electric shock.
Flip the computer upside down.
1024
Step 2
- Locate the two switches that lock the battery. Push the right-hand switch outward into the “unlocked” position.
Locate the two switches that lock the battery. Push the right-hand switch outward into the “unlocked” position.
Step 3
- Push and hold the left hand switch outward in the “unlocked” position, then gently slide the battery away from the computer.
Push and hold the left hand switch outward in the “unlocked” position, then gently slide the battery away from the computer.
Step 4
Back Panel
- Remove the seven 5.3 mm Phillips #1 screws holding the back panel in place.
Remove the seven 5.3 mm Phillips #1 screws holding the back panel in place.
Step 5
- Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly.
- If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly.
If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
Step 6
- The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.
The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.
Step 7
Keyboard
- Remove the two 5.3 mm Phillips #1 screws from the underside of the laptop computer.
- Remove the 4.4 mm Phillips #1 screw located next to the Fan Assembly.
Remove the two 5.3 mm Phillips #1 screws from the underside of the laptop computer.
Remove the 4.4 mm Phillips #1 screw located next to the Fan Assembly.
Step 8
- Flip the computer over.
- Using the plastic opening tool, push in the four small, plastic tabs located at the top of the keyboard.
Flip the computer over.
Using the plastic opening tool, push in the four small, plastic tabs located at the top of the keyboard.
Step 9
- Remove the keyboard by gently pulling the top loose, and then lifting the keyboard out.
- While this step can be accomplished using your hand, it may be easier to use a spudger or plastic opening tool.
Remove the keyboard by gently pulling the top loose, and then lifting the keyboard out.
While this step can be accomplished using your hand, it may be easier to use a spudger or plastic opening tool.
Step 10
- Lift the keyboard up from the bezel.
- Push the gray latch on the keyboard cable ZIF connector forward to unlock it.
- Carefully pull the keyboard cable from its socket.
- Be very careful while unlatching the lock on the keyboard cable ZIF connector. It is extremely delicate and can easily break.
Lift the keyboard up from the bezel.
Push the gray latch on the keyboard cable ZIF connector forward to unlock it.
Carefully pull the keyboard cable from its socket.
Be very careful while unlatching the lock on the keyboard cable ZIF connector. It is extremely delicate and can easily break.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
13 other people completed this guide.
Author
with 7 other contributors
Dennis Wong
Member since: 01/11/2013
570 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team 18-40, Regan Winter 2013
Member of Cal Poly, Team 18-40, Regan Winter 2013
CPSU-REGAN-W13S18G40
5 Members
7 Guides authored
Anand krishnan - May 4, 2017
Reply
Thank you frndzz
Thank you frndz