Featured
Featured Guide
Difficulty
Very difficult
Steps
7
Time Required
20 - 45 minutes
Sections
2
- Tripod Socket
- 3 steps
- Flash Diffuser
- 4 steps
Flags
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackLeica Z2X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the Bottom Screws
- Carefully unscrew the four Phillips #0 screws on the bottom of the camera.
- There is a screw located inside of the tripod hole (large circle.) Make sure the screw is removed from there too!
Carefully unscrew the four Phillips #0 screws on the bottom of the camera.
There is a screw located inside of the tripod hole (large circle.) Make sure the screw is removed from there too!
1024
Step 2
Open the Back Door
- Open the back door on the camera by pushing down on the door latch.
Open the back door on the camera by pushing down on the door latch.
Step 3
Remove the Bottom Plate
- Apply pressure to the bottom plate and it will pop off.
- From here, you can replace the bottom plate, or continue on to further steps.
Apply pressure to the bottom plate and it will pop off.
From here, you can replace the bottom plate, or continue on to further steps.
Step 4
Flash Diffuser
- Now that you’ve removed the bottom plate, you can pull apart the front and back covers.
- Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.
Now that you’ve removed the bottom plate, you can pull apart the front and back covers.
Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.
Step 5
- Next, the back cover.
- Apply pressure to remove the back plate.
- Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.
- The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.
Next, the back cover.
Apply pressure to remove the back plate.
Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.
The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.
Step 6
- You should now have removed the front and back plates.
You should now have removed the front and back plates.
Step 7
- Removing the flash diffuser should be simple from here.
- Simply take the front cover and apply pressure to the front of the flash diffuser and it should pop right out.
Removing the flash diffuser should be simple from here.
Simply take the front cover and apply pressure to the front of the flash diffuser and it should pop right out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Kenny
Member since: 04/10/2011
57 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 18-19, Garner Spring 2011
Member of Cal Poly, Team 18-19, Garner Spring 2011
CPSU-GARNER-S11S18G19
4 Members
12 Guides authored
