Difficulty

Moderate

Steps

6

Time Required

                          1 hour

Sections

1

  • Cabel
  • 6 steps

Flags

3

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLedlenser H8R Stirnlampe

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

No problem, you can solder it back on

What you need

Step 1

              Disassemble the lamp
  • turn and pull the silver focus ring and the lamp will open up

turn and pull the silver focus ring and the lamp will open up

1024

Step 2

              Disassemble the lamp
  • Unscrew 2 screws, you need a Torx T6 for this
  • then remove the white part
  • do not touch the LED!

Unscrew 2 screws, you need a Torx T6 for this

then remove the white part

do not touch the LED!

Step 3

              Clean solder joints
  • Remove residue from the torn cable
  • Remove the cable ties

Remove residue from the torn cable

Remove the cable ties

Step 4

              Which wire goes where?
  • Riddle: which wire goes where?
  • red = D+ / black = D-
  • green = VSS / yellow = SW (= switch)
  • white = NTC (= temperature sensor)

Riddle: which wire goes where?

red = D+ / black = D-

green = VSS / yellow = SW (= switch)

white = NTC (= temperature sensor)

Step 5

              Do not forget !
  • To be on the safe side, remove the battery from the battery compartment
  • Attention, before soldering don’t forget:
  • Thread the cable through the two housings
  • Thread the cable through the kink protection

To be on the safe side, remove the battery from the battery compartment

Attention, before soldering don’t forget:

Thread the cable through the two housings

Thread the cable through the kink protection

Step 6

              Soldering
  • Solder 5 times
  • Secure cable with cable tie
  • Now you can test, but please only briefly, otherwise the LED will get too hot
  • Assemble the lamp!

Solder 5 times

Secure cable with cable tie

Now you can test, but please only briefly, otherwise the LED will get too hot

Assemble the lamp!

Follow these steps in reverse order to reassemble your device

Cancel: I did not complete this guide.

        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    Gottfried Silberhorn

Member since: 02/01/2022

445 Reputation

                                      4 Guides authored                  



                       Badges:
                       3