Leapfrog Leappad Ultimate Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Back Panel
2 steps
Camera
5 steps

Flags

BackLeapFrog LeapPad Ultimate
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Flip over the Pad to its back side to begin the removal of the back panel.
Begin by removing the blue rim along the edge of the device. It runs along the green silicone lining.
This is very difficult to remove , so do be patient. To help remove the seal, both a metal spudger and plastic opening tool may be used.
Remove the pen from its place before starting to avoid tangling.

Flip over the Pad to its back side to begin the removal of the back panel.

Begin by removing the blue rim along the edge of the device. It runs along the green silicone lining.

This is very difficult to remove , so do be patient. To help remove the seal, both a metal spudger and plastic opening tool may be used.

Remove the pen from its place before starting to avoid tangling.

1024

Step 2

Once the blue rim is removed, the 12 screws will be visible.
Use the Phillips #1 screwdriver to unscrew all 12 screws.

Once the blue rim is removed, the 12 screws will be visible.

Use the Phillips #1 screwdriver to unscrew all 12 screws.

Step 3

              Camera

Remove the 3 screws on each corner of the motherboard

Remove the 3 screws on each corner of the motherboard

Step 4

Remove the ribbon on the bottom of the motherboard and the ribbon on the left side of the motherboard.
There will be a small black switch on top of the ribbons that you must flip to take them out.

Remove the ribbon on the bottom of the motherboard and the ribbon on the left side of the motherboard.

There will be a small black switch on top of the ribbons that you must flip to take them out.

Step 5

Remove the 3-pin connector on the top left side of the motherboard.

Remove the 3-pin connector on the top left side of the motherboard.

Step 6

Flip the motherboard to its back side and pinch the 2 green hooks to remove the camera cover

Flip the motherboard to its back side and pinch the 2 green hooks to remove the camera cover

Step 7

Remove the ribbon connecting the camera to the motherboard. You have now taken out the camera and can replace it with a new one.

Remove the ribbon connecting the camera to the motherboard. You have now taken out the camera and can replace it with a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Nabil Mustafa

Member since: 09/21/2018

223 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S1-G13, Riccardelli Fall 2018                        

                                                  Member of University of North Texas, Team S1-G13, Riccardelli Fall 2018 



                    UNT-RICCARDELLI-F18S1G13                     


                                            4 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team