Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

2

  • Battery
  • 4 steps
  • Volume Rocker
  • 2 steps

Flags

0

  • BackLe Pan S

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.
  • This cover is adjacent to the volume button on the side of the Le Pan S.

Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.

This cover is adjacent to the volume button on the side of the Le Pan S.

1024

Step 2

  • Insert the spudger between the front and back panel in order to pry them apart.
  • Do this beside the volume button and the micro SD cover.
  • Pry open the rest of the Le Pan S by dragging the spudger across the side.

Insert the spudger between the front and back panel in order to pry them apart.

Do this beside the volume button and the micro SD cover.

Pry open the rest of the Le Pan S by dragging the spudger across the side.

Step 3

  • Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

Step 4

  • Disconnect the battery from the circuitry and lay it out of the way.
  • The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.
  • If you are replacing your battery, make sure to dispose of it properly.

Disconnect the battery from the circuitry and lay it out of the way.

The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.

If you are replacing your battery, make sure to dispose of it properly.

Step 5

              Volume Rocker
  • Remove the four 2.5 mm Phillips #00 head screws from the circuit board near the top of the tablet.

Remove the four 2.5 mm Phillips #00 head screws from the circuit board near the top of the tablet.

Step 6

  • Pull out the volume rocker by carefully moving it side to side with your fingers.

Pull out the volume rocker by carefully moving it side to side with your fingers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Wiaam Elkhatib

Member since: 09/17/2015

199 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       IUPUI, Team 2-1, Harley Fall 2015                        

                                                  Member of IUPUI, Team 2-1, Harley Fall 2015 



                    IUPUI-HARLEY-F15S2G1                     


                                            5 Members                     


                                            10 Guides authored