Difficulty

Moderate

Steps

8

Time Required

                          5 - 8 minutes

Sections

2

  • Battery
  • 4 steps
  • Camera
  • 4 steps

Flags

0

  • BackLe Pan S

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.
  • This cover is adjacent to the volume button on the side of the Le Pan S.

Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.

This cover is adjacent to the volume button on the side of the Le Pan S.

1024

Step 2

  • Insert the spudger between the front and back panel in order to pry them apart.
  • Do this beside the volume button and the micro SD cover.
  • Pry open the rest of the Le Pan S by dragging the spudger across the side.

Insert the spudger between the front and back panel in order to pry them apart.

Do this beside the volume button and the micro SD cover.

Pry open the rest of the Le Pan S by dragging the spudger across the side.

Step 3

  • Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

Step 4

  • Disconnect the battery from the circuitry and lay it out of the way.
  • The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.
  • If you are replacing your battery, make sure to dispose of it properly.

Disconnect the battery from the circuitry and lay it out of the way.

The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.

If you are replacing your battery, make sure to dispose of it properly.

Step 5

              Camera
  • Remove the four 3.5 mm Phillips #00 screws from the circuit board near the bottom of the tablet.

Remove the four 3.5 mm Phillips #00 screws from the circuit board near the bottom of the tablet.

Step 6

  • Lift and pull the volume rocker up so it is out of the way of the camera.

Lift and pull the volume rocker up so it is out of the way of the camera.

Step 7

  • Remove the zero insertion force connector (ZIF) by using a plastic opening tool, spudger, or fingernail to lift retaining flap.

Remove the zero insertion force connector (ZIF) by using a plastic opening tool, spudger, or fingernail to lift retaining flap.

Step 8

  • Slightly lift up the green electrical board and pull out the camera.

Slightly lift up the green electrical board and pull out the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Tyler Ziliak

Member since: 09/17/2015

110 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team 2-1, Harley Fall 2015                        

                                                  Member of IUPUI, Team 2-1, Harley Fall 2015 



                    IUPUI-HARLEY-F15S2G1                     


                                            5 Members                     


                                            10 Guides authored