Kyocera Qcp 2035 Microphone Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Midframe
4 steps
Microphone
1 step

Flags

BackKyocera QCP-2035
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove Back Cover

When looking at the back of the phone, you will see a horizontal line and three raised segments of plastic in the form of a triangle.
Place thumb on top of the triangle and press into the phone while sliding your thumb towards the bottom of the phone.
In 5 mm it will stop sliding.

When looking at the back of the phone, you will see a horizontal line and three raised segments of plastic in the form of a triangle.

Place thumb on top of the triangle and press into the phone while sliding your thumb towards the bottom of the phone.

In 5 mm it will stop sliding.

1024

Step 2

Grab the bottom of the back cover with your other hand and pull the cover the rest of the way off.
Turn the phone over slowly. The battery will fall out on its own.

Grab the bottom of the back cover with your other hand and pull the cover the rest of the way off.

Turn the phone over slowly. The battery will fall out on its own.

Step 3

Rotate the phone so the bottom is facing you. There is a small indent on the plastic face.
Using the tip of your fingernail or a spudger, pry the cover away from the rest of the phone.
Once the cover starts to part, keep separating until the top notches detach.

Rotate the phone so the bottom is facing you. There is a small indent on the plastic face.

Using the tip of your fingernail or a spudger, pry the cover away from the rest of the phone.

Once the cover starts to part, keep separating until the top notches detach.

Step 4

With the cover plate separated, you will see (6) T6x11mm torx screws recessed in the white plastic.
Remove screws.
The white plastic face plate lifts right off, exposing the main board.

With the cover plate separated, you will see (6) T6x11mm torx screws recessed in the white plastic.

Remove screws.

The white plastic face plate lifts right off, exposing the main board.

Step 5

              Microphone

Locate the microphone at the bottom left corner of the phone.
using tweezers, Lift the microphone straight out of the phone.

Locate the microphone at the bottom left corner of the phone.

using tweezers, Lift the microphone straight out of the phone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    cove

Member since: 01/21/2015

116 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       USF Tampa, Team 5-3, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 5-3, Brown Winter 2015 



                    USFT-BROWN-W15S5G3                     


                                            4 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team