Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
2
- Battery
- 2 steps
- Headphone Jack
- 2 steps
Flags
0
BackKyocera Marbl K127
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the cover on the back of the phone.
- Place your thumbs on the pack of the phone and slide them in a downward motion to remove the cover.
Place your thumbs on the pack of the phone and slide them in a downward motion to remove the cover.
1024
Step 2
Remove the battery
- Use your index finger at the top of the battery and pull it towards your body.
Use your index finger at the top of the battery and pull it towards your body.
Step 3
Remove the phone backing.
- Use the Y1 tri-wing screwdriver to remove the four 2.4mm screws and then pry the entire backing off of the phone including the black clip attached to the top of the motherboard.
Use the Y1 tri-wing screwdriver to remove the four 2.4mm screws and then pry the entire backing off of the phone including the black clip attached to the top of the motherboard.
Step 4
Remove existing headphone jack.
- Locate the headphone jack attached to the top right of the motherboard and pull it off using your thumb and index fingers.
Locate the headphone jack attached to the top right of the motherboard and pull it off using your thumb and index fingers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Brittany Mitchell
Member since: 09/02/2014
309 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
USF Sarasota-Manatee, Team 1-2, Stewart Fall 2014
Member of USF Sarasota-Manatee, Team 1-2, Stewart Fall 2014
USFSM-STEWART-F14S1G2
3 Members
17 Guides authored
