Difficulty

Moderate

Steps

5

Time Required

                          4 - 7 minutes

Sections

2

  • Battery
  • 2 steps
  • Trim
  • 3 steps

Flags

0

  • BackKyocera Hydro Vibe

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Make sure that the device is turned off before beginning.
  • Look for a small indentation on the bottom of the phone.
  • Insert the plastic opening tool into the indentation and lift off the back casing.

Make sure that the device is turned off before beginning.

Look for a small indentation on the bottom of the phone.

Insert the plastic opening tool into the indentation and lift off the back casing.

1024

Step 2

  • The large white component is the battery. Look for a small indentation under the arrow that says “LIFT.”
  • Place the plastic opening tool in the indentation and lift the battery out of the socket.

The large white component is the battery. Look for a small indentation under the arrow that says “LIFT.”

Place the plastic opening tool in the indentation and lift the battery out of the socket.

Step 3

              Trim
  • Locate the screws holding the trim which are the four side screws on each corner.
  • Remove each screw with a Phillips screw driver #J00. The screws are 5mm Phillips.

Locate the screws holding the trim which are the four side screws on each corner.

Remove each screw with a Phillips screw driver #J00. The screws are 5mm Phillips.

Step 4

  • Locate the clasps holding the trim in place.
  • You will need to insert the metal spudger through the bottom of the trim and slowly push upwards to release the clasps.

Locate the clasps holding the trim in place.

You will need to insert the metal spudger through the bottom of the trim and slowly push upwards to release the clasps.

Step 5

  • The trim is flimsy.
  • This is what the trim will look like once removed.

The trim is flimsy.

This is what the trim will look like once removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Phillip Newman

Member since: 01/31/2016

142 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       University of Kentucky Louisville, Team 1-5, Matravers Spring 2016                        

                                                  Member of University of Kentucky Louisville, Team 1-5, Matravers Spring 2016 



                    LOUISVILLE-MATRAVERS-S16S1G5                     


                                            3 Members                     


                                            12 Guides authored