Difficulty

Moderate

Steps

8

Time Required

                          25 - 30 minutes

Sections

2

  • Battery
  • 3 steps
  • Flash and Motherboard
  • 5 steps

Flags

0

  • BackKyocera Echo

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Orient the phone so that the screen is face down.
  • Place one or both thumbs near the small arrow at the bottom of the phone and firmly push the cover up.

Orient the phone so that the screen is face down.

Place one or both thumbs near the small arrow at the bottom of the phone and firmly push the cover up.

1024

Step 2

  • Pull up on the back cover and lift the top to separate it from the phone.

Pull up on the back cover and lift the top to separate it from the phone.

Step 3

  • Pull the battery out of the device with a thin object such as your nail or credit card.

Pull the battery out of the device with a thin object such as your nail or credit card.

Step 4

              Flash and Motherboard
  • Unscrew four 4.3mm Phillips #000 screws.

Unscrew four 4.3mm Phillips #000 screws.

Step 5

  • Unscrew 2 Y1000 4.8 mm screws.

Unscrew 2 Y1000 4.8 mm screws.

Step 6

  • Wedge a plastic opening tool under the black outer casing of the phone. Push the plastic opening tool down and outward while rotating the phone to pry the black outer casing off.
  • Do not apply too much pressure to the outer casing, as it could damage internal components.

Wedge a plastic opening tool under the black outer casing of the phone. Push the plastic opening tool down and outward while rotating the phone to pry the black outer casing off.

Do not apply too much pressure to the outer casing, as it could damage internal components.

Step 7

  • Wedge a plastic opening tool under the motherboard directly above the flash. Additionally, use a plastic opening tool to unhook corner labeled in a red square.

Wedge a plastic opening tool under the motherboard directly above the flash. Additionally, use a plastic opening tool to unhook corner labeled in a red square.

Step 8

  • Gently pull the motherboard out of its compartment.

Gently pull the motherboard out of its compartment.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Alex Kinstedt

Member since: 11/05/2018

483 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       IUPUI, Team S2-G6, Baechle Fall 2018                        

                                                  Member of IUPUI, Team S2-G6, Baechle Fall 2018 



                    IUPUI-BAECHLE-F18S2G6                     


                                            3 Members                     


                                            4 Guides authored