Kurio Xtreme Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          10 minutes

Sections

Back Panel
3 steps
Speaker
2 steps

Flags

BackKurio Xtreme
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

1024

Step 2

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.
There are two screws on each side of the device (four total).

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

There are two screws on each side of the device (four total).

Step 3

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.
Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.
Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.
Carefully lift the back panel off of the rest of the device.

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

Carefully lift the back panel off of the rest of the device.

Step 4

              Speaker

Disconnect the 2 sets of black and red wires (4 wires total) from the motherboard by soldering the ends connected to the motherboard.
The soldering iron gets very hot and may injure you if exposed to your skin.

Disconnect the 2 sets of black and red wires (4 wires total) from the motherboard by soldering the ends connected to the motherboard.

The soldering iron gets very hot and may injure you if exposed to your skin.

Step 5

Carefully remove the speakers out of the plastic molds by lifting up the black and red wires.

Carefully remove the speakers out of the plastic molds by lifting up the black and red wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Mallory Myers

Member since: 09/22/2015

1,163 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Baylor, Team 6-10, Williams Fall 2015                        

                                                  Member of Baylor, Team 6-10, Williams Fall 2015 



                    BU-WILLIAMS-F15S6G10                     


                                            3 Members                     


                                            14 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team