Difficulty

Easy

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Back Panel
  • 3 steps
  • Camera
  • 2 steps

Flags

0

  • BackKurio Xtreme

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

1024

Step 2

  • Unscrew the four 4 mm black screws using a Phillips #000 screw driver.
  • There are two screws on each side of the device (four total).

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

There are two screws on each side of the device (four total).

Step 3

  • Insert the plastic opening tool in between the edges of the blue front casing and black back casing.
  • Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.
  • Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.
  • Carefully lift the back panel off of the rest of the device.

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

Carefully lift the back panel off of the rest of the device.

Step 4

              Camera
  • Remove the flat-topped connector that connects the cameras to the motherboard by using the plastic opening tool to pry up on each side.

Remove the flat-topped connector that connects the cameras to the motherboard by using the plastic opening tool to pry up on each side.

Step 5

  • Remove the smaller, front facing camera by lifting up on the attached ribbon cable.
  • Remove the larger, rear facing camera by lifting up on the attached ribbon cable.

Remove the smaller, front facing camera by lifting up on the attached ribbon cable.

Remove the larger, rear facing camera by lifting up on the attached ribbon cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Mallory Myers

Member since: 09/22/2015

1,163 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Baylor, Team 6-10, Williams Fall 2015                        

                                                  Member of Baylor, Team 6-10, Williams Fall 2015 



                    BU-WILLIAMS-F15S6G10                     


                                            3 Members                     


                                            14 Guides authored