Kurio Xtreme Battery Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          10 minutes

Sections

Back Panel
3 steps
Battery
2 steps

Flags

BackKurio Xtreme
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

1024

Step 2

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.
There are two screws on each side of the device (four total).

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.

There are two screws on each side of the device (four total).

Step 3

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.
Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.
Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.
Carefully lift the back panel off of the rest of the device.

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.

Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.

Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.

Carefully lift the back panel off of the rest of the device.

Step 4

              Battery

Disconnect the black and red wires from the motherboard by soldering the ends that are connected to the motherboard.
The soldering iron gets very hot and may injure you if exposed to your skin.

Disconnect the black and red wires from the motherboard by soldering the ends that are connected to the motherboard.

The soldering iron gets very hot and may injure you if exposed to your skin.

Step 5

Slide iFixit’s Plastic Card tool or a credit card under the battery to remove the glue that is holding it in place.
Be patient and gentle. The glue is strong and may take up to 30 seconds to remove.
Carefully lift the battery out of the device.

Slide iFixit’s Plastic Card tool or a credit card under the battery to remove the glue that is holding it in place.

Be patient and gentle. The glue is strong and may take up to 30 seconds to remove.

Carefully lift the battery out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors

                    Mallory Myers

Member since: 09/22/2015

1,163 Reputation

                                      7 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Baylor, Team 6-10, Williams Fall 2015                        

                                                  Member of Baylor, Team 6-10, Williams Fall 2015 



                    BU-WILLIAMS-F15S6G10                     


                                            3 Members                     


                                            14 Guides authored

j-p1955 - May 14, 2019

j ai changé de batterie mais la batterie ne charge pas. est ce que c ets parce qu un des deux fils serait mal soudé?

Nikki Gilliard - May 28, 2019

Does it have a certain battery or can a different battery fit?

Introduction#

What you need#

Team#

Introduction

What you need

Team