Difficulty

Moderate

Steps

6

Time Required

                          30 minutes

Sections

2

  • Base Plate
  • 3 steps
  • Trigger Assembly
  • 3 steps

Flags

0

  • BackKrups F203

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Base Plate
  • In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

1024

Step 2

  • Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.
  • Try not to break these clips as this will cause structural integrity issues upon reassembly

Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.

Try not to break these clips as this will cause structural integrity issues upon reassembly

Step 3

  • Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

Step 4

              Detach Trigger Button from Base Plate
  • The trigger button is held in with light tension clips. Gently pry them back to release.

The trigger button is held in with light tension clips. Gently pry them back to release.

Step 5

  • Remove the white trigger.

Remove the white trigger.

Step 6

  • Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button
  • Be sure to reference the how to solder video posted to the device page

Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button

Be sure to reference the how to solder video posted to the device page

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors 


                    Ian Hancock

Member since: 10/22/2014

405 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Baylor, Team 4-2, Williams Fall 2014                        

                                                  Member of Baylor, Team 4-2, Williams Fall 2014 



                    BU-WILLIAMS-F14S4G2                     


                                            3 Members                     


                                            8 Guides authored