Difficulty

Easy

Steps

6

Time Required

                          10 - 30 minutes

Sections

1

  • Speaker holder
  • 6 steps

Flags

2

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackKoss Porta Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove cushion
  • Remove cushion using knife.

Remove cushion using knife.

1024

Step 2

              Remove comfortZone label
  • Remove label using flat screwdriver.

Remove label using flat screwdriver.

Step 3

              Remove clip
  • Use screwdriver to start bending edges of clip.
  • Continue bending with pliers or cutters.
  • Push clip with screwdriver and pull with cutters from another side.
  • This step can take up to 15 minutes, so keep calm and continue bending.

Use screwdriver to start bending edges of clip.

Continue bending with pliers or cutters.

Push clip with screwdriver and pull with cutters from another side.

This step can take up to 15 minutes, so keep calm and continue bending.

Step 4

              Remove hoop holder
  • Press tenon using screwdriver to remove shield.
  • Remove hoop from hoop holder.

Press tenon using screwdriver to remove shield.

Remove hoop from hoop holder.

Step 5

              Assemble hoop holder
  • Place hoop in hoop holer.
  • Close hoop holder with shield.
  • Insert M2.5x8 screw into hole and tighten the nut.

Place hoop in hoop holer.

Close hoop holder with shield.

Insert M2.5x8 screw into hole and tighten the nut.

Step 6

              Stick cushion and label
  • Stick comfortZone label over the screw. Use double-sided foam tape if head of screw is too high.
  • Stick cushion. Use additional double-sided tape if cushion has bad holding.

Stick comfortZone label over the screw. Use double-sided foam tape if head of screw is too high.

Stick cushion. Use additional double-sided tape if cushion has bad holding.

Left and right sides are the same so you can use this guide for both.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Дмитрий Кропенко

Member since: 01/30/2020

163 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges