Difficulty
Easy
Steps
4
Time Required
1 minute
Sections
1
- Wheel
- 4 steps
Flags
0
BackKolcraft Cloud Plus
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Wheel
- Applying too much force to the spudger can cause the spudger to bend or the hubcap to break. To avoid this, try prying the hubcap from a different angle or positioning your spudger at a different points around the hubcap.
- Use the spaded side of the metal spudger to pry off the small black hubcap on the outside of the rear wheel.
Applying too much force to the spudger can cause the spudger to bend or the hubcap to break. To avoid this, try prying the hubcap from a different angle or positioning your spudger at a different points around the hubcap.
Use the spaded side of the metal spudger to pry off the small black hubcap on the outside of the rear wheel.
1024
Step 2
- Pull on the looped end of the cotter pin to remove it.
Pull on the looped end of the cotter pin to remove it.
Step 3
- Remove the metal washer by sliding it off the axle.
Remove the metal washer by sliding it off the axle.
Step 4
- Slide the wheel off of the axle.
Slide the wheel off of the axle.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Christopher Peterson
Member since: 10/01/2015
330 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 11-1, Forte Fall 2015
Member of Cal Poly, Team 11-1, Forte Fall 2015
CPSU-FORTE-F15S11G1
4 Members
3 Guides authored
