Difficulty

Moderate

Steps

11

Time Required

                          25 minutes

Sections

3

  • Batteries
  • 3 steps
  • Back Cover
  • 4 steps
  • LCD Screen
  • 4 steps

Flags

0

  • BackKodak PixPro AZ251

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Batteries
  • Slide switch to open lock position.

Slide switch to open lock position.

1024

Step 2

  • Press down on the battery cover and slide outwards to open.

Press down on the battery cover and slide outwards to open.

Step 3

  • Remove the batteries.

Remove the batteries.

Step 4

              Back Cover
  • Remove a total of four 5mm JIS #000 screws from around the camera:
  • Two screws from the right side.
  • Two screws from the left side.

Remove a total of four 5mm JIS #000 screws from around the camera:

Two screws from the right side.

Two screws from the left side.

Step 5

  • Remove the single 5mm Phillips #00 screw from the bottom.

Remove the single 5mm Phillips #00 screw from the bottom.

Step 6

  • Open the flash module.
  • Remove the two 6mm JIS #00 screws found inside of the flash housing.

Open the flash module.

Remove the two 6mm JIS #00 screws found inside of the flash housing.

Step 7

  • Use a plastic opening tool to pry apart both halves of the camera.
  • Remove the back panel.

Use a plastic opening tool to pry apart both halves of the camera.

Remove the back panel.

Step 8

              LCD Screen
  • Remove these three JIS #000 screws from the control board:
  • 5mm screw.
  • 4mm screw.
  • 2mm screw.

Remove these three JIS #000 screws from the control board:

5mm screw.

4mm screw.

2mm screw.

Step 9

  • Pull the small metal switch plate to the side.

Pull the small metal switch plate to the side.

Step 10

  • Pry the LCD screen out of the metal housing plate with a plastic opening tool.

Pry the LCD screen out of the metal housing plate with a plastic opening tool.

Step 11

  • Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.
  • Pull the orange cable out of the socket.

Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

Pull the orange cable out of the socket.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Rachel Llewellyn

Member since: 02/22/2018

509 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team S1-G1, Cagle Spring 2018                        

                                                  Member of USF Tampa, Team S1-G1, Cagle Spring 2018 



                    USFT-CAGLE-S18S1G1                     


                                            4 Members                     


                                            7 Guides authored