Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
2
- Batteries
- 3 steps
- Back Cover
- 4 steps
Flags
0
BackKodak PixPro AZ251
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Batteries
- Slide switch to open lock position.
Slide switch to open lock position.
1024
Step 2
- Press down on the battery cover and slide outwards to open.
Press down on the battery cover and slide outwards to open.
Step 3
- Remove the batteries.
Remove the batteries.
Step 4
Back Cover
- Remove a total of four 5mm JIS #000 screws from around the camera:
- Two screws from the right side.
- Two screws from the left side.
Remove a total of four 5mm JIS #000 screws from around the camera:
Two screws from the right side.
Two screws from the left side.
Step 5
- Remove the single 5mm Phillips #00 screw from the bottom.
Remove the single 5mm Phillips #00 screw from the bottom.
Step 6
- Open the flash module.
- Remove the two 6mm JIS #00 screws found inside of the flash housing.
Open the flash module.
Remove the two 6mm JIS #00 screws found inside of the flash housing.
Step 7
- Use a plastic opening tool to pry apart both halves of the camera.
- Remove the back panel.
Use a plastic opening tool to pry apart both halves of the camera.
Remove the back panel.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Luiza Oliveira
Member since: 02/22/2018
298 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
USF Tampa, Team S1-G1, Cagle Spring 2018
Member of USF Tampa, Team S1-G1, Cagle Spring 2018
USFT-CAGLE-S18S1G1
4 Members
7 Guides authored