Difficulty
Moderate
Steps
7
Time Required
15 minutes
Sections
1
- LCD Screen
- 7 steps
Flags
3
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
Better Introduction
Improve this guide by completing or revising its introduction.
BackKodak Easyshare Z981
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
LCD Screen
- Open the battery cover and remove batteries from the camera if any are inserted.
Open the battery cover and remove batteries from the camera if any are inserted.
1024
Step 2
- Use a 00 Phillips-Head screwdriver to remove screws:
- Remove the 3 mm screws from the camera
- Four (4) screws are in the bottom of the device
- Four (4) screws are inside the battery cover
Use a 00 Phillips-Head screwdriver to remove screws:
Remove the 3 mm screws from the camera
Four (4) screws are in the bottom of the device
Four (4) screws are inside the battery cover
Step 3
- Start from a corner and gently remove the cover.
- The cover will easily lift off, so not much pressure is required.
- Make sure to gently remove the bottom cover in order to avoid breaking the plastic.
Start from a corner and gently remove the cover.
The cover will easily lift off, so not much pressure is required.
Make sure to gently remove the bottom cover in order to avoid breaking the plastic.
Step 4
- Use a Phillips #00 Screwdriver to remove the 4 mm screws from each side of the back cover of the camera.
- Two (2) screws are located in the left side of the device
- Two (2) screws are locatecd in the right side of the device
Use a Phillips #00 Screwdriver to remove the 4 mm screws from each side of the back cover of the camera.
Two (2) screws are located in the left side of the device
Two (2) screws are locatecd in the right side of the device
Step 5
- Insert the Plastic Opening Tool in to the crevices of back cover and gently apply pressure
- Be gentle while removing the cover, to avoid cracking the case
Insert the Plastic Opening Tool in to the crevices of back cover and gently apply pressure
Be gentle while removing the cover, to avoid cracking the case
Step 6
- Once the back cover is removed locate the four 3mm screws holding the screen and the metal brace to the circuit board
Once the back cover is removed locate the four 3mm screws holding the screen and the metal brace to the circuit board
Step 7
- Gently lift up the metal brace and use a pair to disconnect the ribbon cable connecter
- Use Tweezers to disconnect the ribbon cable connector.
- Once disconnected remove the screen brace from the circuit board
- Use extreme caution when removing the LCD brace pulling the brace may tear the cable
Gently lift up the metal brace and use a pair to disconnect the ribbon cable connecter
Use Tweezers to disconnect the ribbon cable connector.
Once disconnected remove the screen brace from the circuit board
Use extreme caution when removing the LCD brace pulling the brace may tear the cable
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Daniel Ramirez
Member since: 03/03/2015
152 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
Sam Houston State, Team 13-6, Blackburne Winter 2015
Member of Sam Houston State, Team 13-6, Blackburne Winter 2015
SHSU-BLACKBURNE-W15S13G6
3 Members
9 Guides authored
