Difficulty

Very difficult

Steps

12

Time Required

                          45 minutes

Sections

2

  • Battery
  • 5 steps
  • Lens
  • 7 steps

Flags

0

  • BackKodak Easyshare V1003

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn off camera by firmly pressing the power button that is located on the top of the camera.

Turn off camera by firmly pressing the power button that is located on the top of the camera.

1024

Step 2

  • Position camera with the bottom facing up.

Position camera with the bottom facing up.

Step 3

  • With your finger, slide the battery cover in the direction of the open arrow.

With your finger, slide the battery cover in the direction of the open arrow.

Step 4

  • Lift the battery cover up gently.

Lift the battery cover up gently.

Step 5

  • Gently push the battery down until a click is heard. Battery should release and be lifted out of slot.

Gently push the battery down until a click is heard. Battery should release and be lifted out of slot.

Step 6

              Lens
  • Use a J00 screwdriver to remove the five exterior screws.

Use a J00 screwdriver to remove the five exterior screws.

Step 7

  • Pull the outer case off using the plastic opening tool.

Pull the outer case off using the plastic opening tool.

Step 8

  • Remove the LCD display by unplugging the connector
  • Take apart the LCD display from the back case

Remove the LCD display by unplugging the connector

Take apart the LCD display from the back case

Step 9

  • Peel off the yellow film.
  • Peel off the black tape holding the wires.

Peel off the yellow film.

Peel off the black tape holding the wires.

Step 10

  • Unplug the connector by lifting the little lock holding it in place.

Unplug the connector by lifting the little lock holding it in place.

Step 11

  • Use a J00 screwdriver to remove two screws located on the far right, near to the main button.

Use a J00 screwdriver to remove two screws located on the far right, near to the main button.

Step 12

  • Use a J00 screwdriver to remove 6 screws located at the center of the back panel.
  • Gently pull out the lens using you finger tips or pincers.

Use a J00 screwdriver to remove 6 screws located at the center of the back panel.

Gently pull out the lens using you finger tips or pincers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Sarah Berry

Member since: 03/21/2017

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       UMass Dartmouth, Team S9-G4, Martin Spring 2017                        

                                                  Member of UMass Dartmouth, Team S9-G4, Martin Spring 2017 



                    UMASSD-MARTIN-S17S9G4                     


                                            4 Members                     


                                            10 Guides authored