Difficulty
Moderate
Steps
10
Time Required
Suggest a time??
Sections
1
- Screen
- 10 steps
Flags
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackKodak EasyShare
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Open the battery compartment on the bottom of the camera and remove the battery.
Open the battery compartment on the bottom of the camera and remove the battery.
1024
Step 2
- Remove two Phillips screws from each side of the camera (four screws total).
- Remove one additional Phillips screw from the bottom of the camera.
Remove two Phillips screws from each side of the camera (four screws total).
Remove one additional Phillips screw from the bottom of the camera.
Step 3
- Inserting the prying tool as shown, gently separate the front and back pieces of the camera exterior.
Inserting the prying tool as shown, gently separate the front and back pieces of the camera exterior.
Step 4
- Carefully remove the front and back exterior pieces from the camera body.
Carefully remove the front and back exterior pieces from the camera body.
Step 5
- Gently remove the frame with the top buttons.
- You should now have the screen and inside parts exposed as shown.
Gently remove the frame with the top buttons.
You should now have the screen and inside parts exposed as shown.
Step 6
- Lift the screen off the body. Note that it is still connected on one side by the orange tape.
- Flip it over gently and let it rest off to the side where the tape is.
- It is okay if the orange tape clips out of its spot.
Lift the screen off the body. Note that it is still connected on one side by the orange tape.
Flip it over gently and let it rest off to the side where the tape is.
It is okay if the orange tape clips out of its spot.
Step 7
- Remove the two Phillips screws. There is one at the top center and one in the bottom left corner.
Remove the two Phillips screws. There is one at the top center and one in the bottom left corner.
Step 8
- Remove the top Phillips screw from the right side.
- Move the silver tape aside to access and remove the Phillips screw in the bottom corner.
Remove the top Phillips screw from the right side.
Move the silver tape aside to access and remove the Phillips screw in the bottom corner.
Step 9
- Gently pry up the clip on the top corner to release the metal casing and lift the casing out of the way.
- The casing is also connected via an orange tape on the right side that you may leave in place.
- Be sure to wear safety glasses while prying the clip.
Gently pry up the clip on the top corner to release the metal casing and lift the casing out of the way.
The casing is also connected via an orange tape on the right side that you may leave in place.
Be sure to wear safety glasses while prying the clip.
Step 10
- Find the silver clip where the orange tape from the screen attaches to the circuit board.
- Lift up the silver clip. The orange tape will slide out, completely disconnecting the screen from the camera.
Find the silver clip where the orange tape from the screen attaches to the circuit board.
Lift up the silver clip. The orange tape will slide out, completely disconnecting the screen from the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 10 other contributors
Samantha Vasquez
Member since: 05/31/2016
101 Reputation
1 Guide authored
Badges:
2
Team
Central Coast New Tech High, Team 4-8, Rushing Spring 2016
Member of Central Coast New Tech High, Team 4-8, Rushing Spring 2016
CCNTH-RUSHING-S16S4G8
2 Members
1 Guide authored
