Difficulty
Moderate
Steps
10
Time Required
10 minutes
Sections
3
- Battery
- 2 steps
- Back Panel Frame
- 2 steps
- Screen
- 6 steps
Flags
1
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
BackKodak EasyShare M381
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- First, press in and slide forward the battery latch as indicated by the arrow.
First, press in and slide forward the battery latch as indicated by the arrow.
1024
Step 2
- Press down on battery until you hear a click and release it. Battery should easily slide out.
Press down on battery until you hear a click and release it. Battery should easily slide out.
Step 3
Back Panel Frame
- Obtain screwdriver, and remove the 3.85 mm frame screws as highlighted.
- Using a magnetized surface to keep from losing screws may be very helpful.
Obtain screwdriver, and remove the 3.85 mm frame screws as highlighted.
Using a magnetized surface to keep from losing screws may be very helpful.
Step 4
- After screws are removed, using both hands, carefully pull the frame apart from the camera as indicated.
After screws are removed, using both hands, carefully pull the frame apart from the camera as indicated.
Step 5
Screen
- Remove the two 3.85 mm screws on the bottom right of the camera, as indicated.
Remove the two 3.85 mm screws on the bottom right of the camera, as indicated.
Step 6
- Remove dial button located on top of camera, by gently pulling up.
Remove dial button located on top of camera, by gently pulling up.
Step 7
- Starting at one side, carefully work the chrome frame off of the camera itself.
- Be careful not to disturb the shutter or flash buttons on top of the camera.
Starting at one side, carefully work the chrome frame off of the camera itself.
Be careful not to disturb the shutter or flash buttons on top of the camera.
Step 8
- On the right side of the camera, locate and remove the two 3.25 mm screws as highlighted.
On the right side of the camera, locate and remove the two 3.25 mm screws as highlighted.
Step 9
- Carefully lift the motherboard panel up, pulling towards the left. Make sure you do not rip the blue ribbon.
- Using a plastic opening tool, gently lift up on the ribbon fastener until it is in an upright position.
- Slide panel away from camera.
Carefully lift the motherboard panel up, pulling towards the left. Make sure you do not rip the blue ribbon.
Using a plastic opening tool, gently lift up on the ribbon fastener until it is in an upright position.
Slide panel away from camera.
Step 10
- Using a plastic opening tool, gently lift ribbon clamp as indicated to remove the screen ribbon from the motherboard.
- Screen should now be detached. Gently lift it away from the base of the camera.
Using a plastic opening tool, gently lift ribbon clamp as indicated to remove the screen ribbon from the motherboard.
Screen should now be detached. Gently lift it away from the base of the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Christina Hamby
Member since: 01/30/2015
437 Reputation
4 Guides authored
Badges:
12
+9 more badges
Team
University of Kentucky Louisville, Team 1-4, Rountree Winter 2015
Member of University of Kentucky Louisville, Team 1-4, Rountree Winter 2015
LOUISVILLE-ROUNTREE-W15S1G4
4 Members
14 Guides authored
