Difficulty

Moderate

Steps

8

Time Required

                          5 - 10 minutes

Sections

4

  • Batteries
  • 1 step
  • Back Case
  • 2 steps
  • Front Case
  • 1 step
  • Capacitor
  • 4 steps

Flags

0

  • BackKodak EasyShare C913

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Batteries
  • Position the camera with the bottom facing up.
  • With your finger, slide the battery cover in the direction of open arrow.
  • The battery cover will spring open, so be careful to lift it up gently.

Position the camera with the bottom facing up.

With your finger, slide the battery cover in the direction of open arrow.

The battery cover will spring open, so be careful to lift it up gently.

1024

Step 2

              Back Case
  • Use a Phillips #00 screwdriver to remove the seven 4.5mm screws.
  • There are 2 on the left
  • There are 2 on the right
  • There are 3 on the bottom

Use a Phillips #00 screwdriver to remove the seven 4.5mm screws.

There are 2 on the left

There are 2 on the right

There are 3 on the bottom

Step 3

  • Firmly grasp and pull back casing off.

Firmly grasp and pull back casing off.

Step 4

              Front Case
  • With battery door open, grasp the front case and remove it from the camera.

With battery door open, grasp the front case and remove it from the camera.

Step 5

              Capacitor
  • Orient the camera with the lens facing you.
  • Use a Phillips #00 screwdriver to remove the one 2.2mm screw on the plastic bridge.
  • Lift the plastic bridge off and place it to the side.

Orient the camera with the lens facing you.

Use a Phillips #00 screwdriver to remove the one 2.2mm screw on the plastic bridge.

Lift the plastic bridge off and place it to the side.

Step 6

  • Do not touch the capacitor contact points for any reason. This will result in a severe shock.

Do not touch the capacitor contact points for any reason. This will result in a severe shock.

Step 7

  • Grasp the capacitor, carefully remove it from its holder, and place it off to the side.

Grasp the capacitor, carefully remove it from its holder, and place it off to the side.

Step 8

  • De-solder the connections at the base of the capacitor

De-solder the connections at the base of the capacitor

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Alan Galarza

Member since: 10/03/2010

72 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 7-51, Amido Fall 2010                        

                                                  Member of Cal Poly, Team 7-51, Amido Fall 2010 



                    CPSU-AMIDO-F10S7G51                     


                                            4 Members                     


                                            14 Guides authored