Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

3

  • Batteries
  • 2 steps
  • Outer Case
  • 2 steps
  • Capacitor
  • 2 steps

Flags

0

  • BackKodak EasyShare C713

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Batteries
  • Use your finger tip to slide battery cover door away from the center of the camera.
  • The battery door should spring open.
  • If this does not happen, gently open the door lifting from the outer bottom side of the camera.

Use your finger tip to slide battery cover door away from the center of the camera.

The battery door should spring open.

If this does not happen, gently open the door lifting from the outer bottom side of the camera.

1024

Step 2

  • Remove the old batteries.

Remove the old batteries.

Step 3

              Outer Case
  • Remove the seven screws from the outer case with a Phillips #00.
  • All screws are 4.45mm.
  • There are 2 screws on the port side.
  • There are 2 screws on starboard side.
  • There are 3 screws on the bottom.

Remove the seven screws from the outer case with a Phillips #00.

All screws are 4.45mm.

There are 2 screws on the port side.

There are 2 screws on starboard side.

There are 3 screws on the bottom.

Step 4

  • Make sure the battery cap is “up”.
  • Pull the outer case off with your hands.

Make sure the battery cap is “up”.

Pull the outer case off with your hands.

Step 5

              Capacitor
  • To avoid an electric shock, do not to touch capacitor.
  • The capacitor is located underneath the lens.
  • It is held in place by 4 plastic snaps; it can be easily removed by pulling outward with your fingers.

To avoid an electric shock, do not to touch capacitor.

The capacitor is located underneath the lens.

It is held in place by 4 plastic snaps; it can be easily removed by pulling outward with your fingers.

Step 6

  • Desolder points connecting capacitor to circuit board.

Desolder points connecting capacitor to circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Scott DiGirolamo

Member since: 04/15/2010

46 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 26-19, Regan Spring 2010                        

                                                  Member of Cal Poly, Team 26-19, Regan Spring 2010 



                    CPSU-REGAN-S10S26G19                     


                                            4 Members                     


                                            14 Guides authored