Kodak Easyshare C142 Lcd Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          15 - 30 minutes            

Sections

1

• LCD
• 3 steps

Flags

4

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackKodak EasyShare C142

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              LCD               

• Remove the batteries and memory card from the camera.
• Remove a total of four screws on either side of the camera.

Remove the batteries and memory card from the camera.

Remove a total of four screws on either side of the camera.

1024

Step 2

• Remove the two (2) screws from the bottom of the camera.
• Split the case from the battery compartment carefully until the rear case is separated from the rest of the camera, as shown in the third image.

Remove the two (2) screws from the bottom of the camera.

Split the case from the battery compartment carefully until the rear case is separated from the rest of the camera, as shown in the third image.

Step 3

• Carefully slide the LCD out of its holder until the connector is visible. Open the clip on the connector by pulling it with your fingernail to the right of the screen.
• Remove the damaged LCD and insert the replacement.
• After clipping the connector again, reassemble the camera using the six (6) previously removed screws.

Carefully slide the LCD out of its holder until the connector is visible. Open the clip on the connector by pulling it with your fingernail to the right of the screen.

Remove the damaged LCD and insert the replacement.

After clipping the connector again, reassemble the camera using the six (6) previously removed screws.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 

                    oldturkey03                     

Member since: 09/29/2010

722,317 Reputation

                                      109 Guides authored                  



                       Badges:
                       53







                                                        +50 more badges                           

Team

                       Global Fixers                        

                                                  Member of Global Fixers 



                    Community                     


                                            22 Members                     


                                            240 Guides authored