Difficulty

Very easy

Steps

5

Time Required

                          2 - 5 minutes

Sections

2

  • Case
  • 3 steps
  • Wiring Harness
  • 2 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackKobold VK150

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove screws from housing
  • Use a TX10 screwdriver
  • Remove the housing screws on the rear of the device.
  • 6 long screws
  • 3 short screws

Use a TX10 screwdriver

Remove the housing screws on the rear of the device.

6 long screws

3 short screws

1024

Step 2

              Remove housing cover
  • Place the device with the white lid facing up.
  • Start to carefully lift the lid at the front of the suction nozzle. Slowly work your way up to the stem.
  • At the top of the stem, a small plastic part holds in the gray casing of the suction cup!

Place the device with the white lid facing up.

Start to carefully lift the lid at the front of the suction nozzle. Slowly work your way up to the stem.

At the top of the stem, a small plastic part holds in the gray casing of the suction cup!

Step 3

              Separate parts
  • Now you can lift the flap of the vacuum cleaner bag. This was only held by the white lid.

Now you can lift the flap of the vacuum cleaner bag. This was only held by the white lid.

Step 4

              Remove the plug
  • Disconnect the power supply connector by pressing the unlocking lever.
  • Unplug the motherboard connector.
  • Put the cable aside

Disconnect the power supply connector by pressing the unlocking lever.

Unplug the motherboard connector.

Put the cable aside

Step 5

              Remove the wiring harness
  • Unlock and loosen the rotary switch plug.
  • Disconnect the white air hose from the intake manifold.
  • Release 2 plastic clips
  • Remove the wiring harness with the plastic holder.

Unlock and loosen the rotary switch plug.

Disconnect the white air hose from the intake manifold.

Release 2 plastic clips

Remove the wiring harness with the plastic holder.

Follow the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    Lukas Fritz

Member since: 12/25/2019

362 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges