Kitchenaid Ksb5Cr Ribbon Cable Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 minutes            

Sections

2

• Back Panel
• 2 steps
• Ribbon Cable
• 2 steps

Flags

0

• BackKitchenAid KSB5CR Blender

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Removing the Back Panel Part 1               

• Remove the glass container and place the blender upside down on a solid surface.
• Remove the four rubber feet using the needle nose pliers.
• Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.

Remove the glass container and place the blender upside down on a solid surface.

Remove the four rubber feet using the needle nose pliers.

Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.

1024

Step 2

              Removing the Back Panel Part 2               

• Lift the back panel up, sliding it along the power cord.

Lift the back panel up, sliding it along the power cord.

Step 3

              Removing the O-Ring               

• Remove the two #6 Hex 82mm screws using the Phillips #2 screwdriver.
• Remove the rubber O-ring by lifting it up.

Remove the two #6 Hex 82mm screws using the Phillips #2 screwdriver.

Remove the rubber O-ring by lifting it up.

Step 4

              Removing the Ribbon Cable               

• Remove the ribbon cable from the chassis by lifting it up.
• Remove the other end of the ribbon cable from the circuit board by lifting it up.

Remove the ribbon cable from the chassis by lifting it up.

Remove the other end of the ribbon cable from the circuit board by lifting it up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Cameron Geehr                     

Member since: 09/28/2014

721 Reputation

                                      6 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       Cal Poly, Team 12-5, Forte Fall 2014                        

                                                  Member of Cal Poly, Team 12-5, Forte Fall 2014 



                    CPSU-FORTE-F14S12G5                     


                                            5 Members                     


                                            6 Guides authored