Kitchenaid Ksb5Cr Power Cable Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 minutes            

Sections

2

• Back Panel
• 2 steps
• Power Cable
• 3 steps

Flags

0

• BackKitchenAid KSB5CR Blender

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Removing the Back Panel Part 1               

• Remove the glass container and place the blender upside down on a solid surface.
• Remove the four rubber feet using the needle nose pliers.
• Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.

Remove the glass container and place the blender upside down on a solid surface.

Remove the four rubber feet using the needle nose pliers.

Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.

1024

Step 2

              Removing the Back Panel Part 2               

• Lift the back panel up, sliding it along the power cord.

Lift the back panel up, sliding it along the power cord.

Step 3

              Freeing the Power Cable               

• Lift up on the power cable to pop it out of its holder.

Lift up on the power cable to pop it out of its holder.

Step 4

              Detaching the White and Black Wires               

• Be gentle with the knife or you will break the circuit board.
• Slide the knife into the metal loop holding the insulation before the white copper wire, and wiggle it back and forth until it loosens.
• Pull the wire out from the metal loop that you loosened.
• Repeat this process with the black copper wire.

Be gentle with the knife or you will break the circuit board.

Slide the knife into the metal loop holding the insulation before the white copper wire, and wiggle it back and forth until it loosens.

Pull the wire out from the metal loop that you loosened.

Repeat this process with the black copper wire.

Step 5

              Detatching the Green Wire               

• Using the Phillips #2 screwdriver, remove the #8 Phillips 6mm screw to which the green wire is attached.

Using the Phillips #2 screwdriver, remove the #8 Phillips 6mm screw to which the green wire is attached.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Cameron Geehr                     

Member since: 09/28/2014

721 Reputation

                                      6 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges                           

Team

                       Cal Poly, Team 12-5, Forte Fall 2014                        

                                                  Member of Cal Poly, Team 12-5, Forte Fall 2014 



                    CPSU-FORTE-F14S12G5                     


                                            5 Members                     


                                            6 Guides authored