Kitchenaid Khm512Er Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Power Cord
6 steps

Flags

BackKitchenAid KHM512ER
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Cord

Insert the back of a plastic opening tool into one of the beater holes
Apply force to pull the circular plastic part off.
If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.

Insert the back of a plastic opening tool into one of the beater holes

Apply force to pull the circular plastic part off.

If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.

1024

Step 2

Use a plastic opening tool to remove the speed knob.
Pop up the panel with a plastic opening tool.
Use a plastic opening tool to pry the white plastic switch assembly out.

Use a plastic opening tool to remove the speed knob.

Pop up the panel with a plastic opening tool.

Use a plastic opening tool to pry the white plastic switch assembly out.

Step 3

Use a Phillips 2 screwdriver to remove the two 20.0mm screws that hold the bottom plastic piece.
Your screwdriver may not be long or narrow enough to reach the screws in these holes. If that’s the case, use another screwdriver.
Remove the bottom plastic piece using a plastic opening tool.

Use a Phillips 2 screwdriver to remove the two 20.0mm screws that hold the bottom plastic piece.

Your screwdriver may not be long or narrow enough to reach the screws in these holes. If that’s the case, use another screwdriver.

Remove the bottom plastic piece using a plastic opening tool.

Step 4

Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.
Use your hands to remove the motor assembly and circuit board.

Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.

Use your hands to remove the motor assembly and circuit board.

Step 5

Firmly grip the circuit board, and using pliers, remove the black and white power cord connectors from the circuit board.
Some force may be required. Be careful not to cut yourself on any electrical components.

Firmly grip the circuit board, and using pliers, remove the black and white power cord connectors from the circuit board.

Some force may be required. Be careful not to cut yourself on any electrical components.

Step 6

Using a plastic opening tool, remove the white plastic clip on the inside of the bottom plastic piece.
Once it’s loose, remove it with your fingers.
Pull the power cord through the hole.

Using a plastic opening tool, remove the white plastic clip on the inside of the bottom plastic piece.

Once it’s loose, remove it with your fingers.

Pull the power cord through the hole.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Brad Daniels

Member since: 02/10/2016

561 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 2-3, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 2-3, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S2G3                     


                                            3 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team