Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes

Sections

1

  • Eject Button Spring
  • 5 steps

Flags

0

  • BackKitchenAid KHM512ER

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Eject Button Spring
  • Insert the back of a plastic opening tool into one of the beater holes.
  • Apply force to pull the circular plastic part off.
  • If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.

Insert the back of a plastic opening tool into one of the beater holes.

Apply force to pull the circular plastic part off.

If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.

1024

Step 2

  • Use a plastic opening tool to remove the speed knob.
  • Use a plastic opening tool to remove the long plastic piece
  • Use a plastic opening tool to remove the speed switch.

Use a plastic opening tool to remove the speed knob.

Use a plastic opening tool to remove the long plastic piece

Use a plastic opening tool to remove the speed switch.

Step 3

  • Use a Phillips 2 screwdriver to remove the two 20.0mm screws holding the bottom plastic piece on.
  • Your screwdriver may not be long or narrow enough to reach the screws in these holes. If that’s the case, use another screwdriver.
  • Remove the bottom plastic piece using a plastic opening tool.

Use a Phillips 2 screwdriver to remove the two 20.0mm screws holding the bottom plastic piece on.

Your screwdriver may not be long or narrow enough to reach the screws in these holes. If that’s the case, use another screwdriver.

Remove the bottom plastic piece using a plastic opening tool.

Step 4

  • Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.
  • Use your hands to remove the motor assembly.
  • Use your hands to hold the eject button from one side while using the other hand to remove the circuit board.

Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.

Use your hands to remove the motor assembly.

Use your hands to hold the eject button from one side while using the other hand to remove the circuit board.

Step 5

  • Remove the eject button by pulling it from the inside of the mixer.
  • Hold the eject button firmly while pulling out the spring.

Remove the eject button by pulling it from the inside of the mixer.

Hold the eject button firmly while pulling out the spring.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Yuriy Zaynulin

Member since: 02/10/2016

191 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 2-3, Sullivan Spring 2016                        

                                                  Member of USF Tampa, Team 2-3, Sullivan Spring 2016 



                    USFT-SULLIVAN-S16S2G3                     


                                            3 Members                     


                                            4 Guides authored