Difficulty
Very easy
Steps
1
Time Required
10 - 20 minutes
Sections
- Planetary Assembly
- 1 step
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackKitchenAid 7 Quart Bowl-Lift Stand Mixer with Redesigned Premium Touchpoints (KSM70SN)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the Planetary Assembly
- Place some dish towels or other soft material in the base to protect it from any potential impact.
- Disconnect the planetary from the motor drive shaft by removing the retaining pin (circled in yellow). You can do this with a hammer and either a pin punch or a Torx T15 screwdriver. Simply hammer the punch/screwdriver on the pin until it comes out the other side.
- If the planetary assembly doesn’t fall out, you might have to give it a firm pull straight down to remove it.
Place some dish towels or other soft material in the base to protect it from any potential impact.
Disconnect the planetary from the motor drive shaft by removing the retaining pin (circled in yellow). You can do this with a hammer and either a pin punch or a Torx T15 screwdriver. Simply hammer the punch/screwdriver on the pin until it comes out the other side.
If the planetary assembly doesn’t fall out, you might have to give it a firm pull straight down to remove it.
1024
To reassemble your device, follow these instructions in reverse order. Take care to ensure the hole in the planetary assembly is aligned properly with the hole in the motor shaft before hammering the pin back in.
Cancel: I did not complete this guide.
Author
PedroDaGr8
Member since: 08/12/2012
962 Reputation
8 Guides authored
Badges:
4
+1 more badge