Difficulty

Moderate

Steps

8

Time Required

                          35 minutes

Sections

1

  • Rear drawer mounts
  • 8 steps

Flags

0

  • BackHome Construction

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear drawer mounts
  • Remove all utensils from the drawer and remove the drawer from the slot.

Remove all utensils from the drawer and remove the drawer from the slot.

1024

Step 2

  • Start removing the mounts and tracks by unscrewing them with your drill or screwdriver.
  • Your replacement tracks or mounts will come with new screws.

Start removing the mounts and tracks by unscrewing them with your drill or screwdriver.

Your replacement tracks or mounts will come with new screws.

Step 3

  • Once you have all your new material, insert the mounts onto your track.

Once you have all your new material, insert the mounts onto your track.

Step 4

  • Take the track with the new mount attached and screw it into the existing hole using the new screws that came in the packaging.

Take the track with the new mount attached and screw it into the existing hole using the new screws that came in the packaging.

Step 5

  • After the track has one screw drilled, use a level to make sure your track is straight.
  • Depending on your new mounts, you may or may not need to drill new holes for the screws. If you do need to drill new holes mark the holes on the mount with a pencil or marker.

After the track has one screw drilled, use a level to make sure your track is straight.

Depending on your new mounts, you may or may not need to drill new holes for the screws. If you do need to drill new holes mark the holes on the mount with a pencil or marker.

Step 6

  • Drill the screws in either the existing holes or marked spots to hold the mount in place.

Drill the screws in either the existing holes or marked spots to hold the mount in place.

Step 7

  • Repeat these steps on the other side if needed.

Repeat these steps on the other side if needed.

Step 8

  • Place your drawer back into its place and you are now done with your repair!

Place your drawer back into its place and you are now done with your repair!

Now that your repair is done make sure your drawer is sliding smoothly if not you will need to remove it and clean the tracks. Another thing to look for is if the tracks are perfectly aligned if not you can go back in and fix them by following the same steps again.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Valeria Covarrubias

Member since: 04/13/2020

182 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Eastern Washington University, Team S25-G1, Crane Spring 2020                        

                                                  Member of Eastern Washington University, Team S25-G1, Crane Spring 2020 



                    EWU-CRANE-S20S25G1                     


                                            4 Members                     


                                            1 Guide authored