Difficulty
Easy
Steps
6
Time Required
10 minutes
Sections
1
- Vacuum Belt
- 6 steps
Flags
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackVacuum Cleaner
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Vacuum Belt
- Place the vacuum at an angle most comfortable and easy to access with the bottom facing upwards.
Place the vacuum at an angle most comfortable and easy to access with the bottom facing upwards.
1024
Step 2
- Remove the three screws holding the base plate to the body of the vacuum using a flat head screwdriver.
- Place the plate to the side.
Remove the three screws holding the base plate to the body of the vacuum using a flat head screwdriver.
Place the plate to the side.
Step 3
- Simply slide the roller out of the vacuum.
- The belt is attached to the roller on either side.
Simply slide the roller out of the vacuum.
The belt is attached to the roller on either side.
Step 4
- Slide the vacuum belt out from beneath the wheel holding it in place.
Slide the vacuum belt out from beneath the wheel holding it in place.
Step 5
- Insert your new belt and pop the roller back into place.
Insert your new belt and pop the roller back into place.
Step 6
- Secure the plate once again until it clicks into the made grooves.
- Secure the three screws until tightened.
Secure the plate once again until it clicks into the made grooves.
Secure the three screws until tightened.
Make sure to test the vacuum and securely tighten all screws. With that, you’re good to go!
Cancel: I did not complete this guide.
Author
with 1 other contributor
Gina Trojano
Member since: 04/22/2021
133 Reputation
1 Guide authored
Badges:
2
Team
UMass Dartmouth, Team S2-G23, Sinclaire Spring 2021
Member of UMass Dartmouth, Team S2-G23, Sinclaire Spring 2021
UMASSD-SINCLAIRE-S21S2G23
1 Member
1 Guide authored
